Kenmore 1T6.29429 - Manual (Page 14)

POWER-IVIATE^« CARE
Always follow ail safety precautions when
cleaning and servicing the POWER-MATE'^
A
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit
Failure to do so could result in elec­
trical shock or persona! injury from
cleaner suddenly starting.
LIGHT BULB CHANGING
1. Remove light
cover by pressing
in and lifting both
sides as shown*
Push !n
And Turn
2. Push in and turn
bulb counterclock­
wise to remove.
3. Replace the bulb.
Bulb must not be
higher than 15 Watts,
Close light cover until
it snaps in place.
NOTE: See PARTS AND FEATURES for
Buib #
BELT CHANGING AND BRUSH CLEANING
Disconnect cleaner from electrical outlet
Check and remove hair, string and lint build­
up frequently in the POWER-MATE™ brush
and brush support areas. If build-up
becomes excessive, disconnect POWER­
MATE™ from wand and follow the steps
below. Instructions can also be found under
the light cover.
I mCw-IVlVi^V C" m
j f 1. Remove light
cover and light
bulb as shown
under LIGHT
BULB
CHANGING.
2. Unscrew the
POWER­
MATE™ cover
i , — ¡ A - --------- screws.
3. Turn
POWER­
MATE™ over.
To remove
cover, insert
screwdriver at
cover tabs on
both sides and
twist to
release tabs
Quick
Release
4. Turn POWER­
MATE™ right
side up. Press
handle release
pedal and lower
the swivel, Tilt
cover forward
from back until
front snaps free.
14