Troubleshooting guide (cont’d), Operational conditions (cont’d), High temperature shut off system – Kenmore 153.330752 User Manual

Page 24: Awarning, Not enough or no hot water, Water is too hot

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Troubleshooting Guide (cont’d)

Operational Conditions (cont’d)

HIGH TEMPERATURE SHUT OFF SYSTEM

This water heater is equipped with an automatic gas shut off sys­
tem. The high temperature shut off is built into the gas control
valve. This system shuts off the gas supply to the water heater
burners when high water temperatures are present. It is non­
resettable. If the high temperature shut off activates, the gas con­
trol valve must be replaced. If this were to occur, turn “OFF” the
entire gas supply to the water heater. Contact the Sears Service
Center.

AWARNING

Should overheating occur or the gas supply fail to shut off,

turn “OFF” the manual gas control valve to the appliance.

NOT ENOUGH OR NO HOT WATER

• Check the manual gas shut off valve to be sure it is open,

• Check the pilot flame. It may have gone out. All models have

an opening behind the outer door for viewing the pilot.

• If the pilot is not lit, follow the “Lighting” instructions in this

manual or located above the gas control valve on the water
heater to relight the pilot. If the water was extremely hoc and is
now cold, the high limit safety temperature shut off may have
put out the burner and pitot. If the high temperature shut off
activates, the gas control valve must be replaced. Contact the
Sears Service Center.

• The gas control knob must be turned to the “ON” position.

• The temperature adjustment dial may be set too low. See the

“Temperature Regulation” section.

• The gas company can check the gas input to see if it is correct.

An underfired water heater will not heat water as quickly.

• Look for leaking or open hot water faucets. Make sure all are

closed.

The cold water inlet temperature may be colder during the

winter months. It will take longer to heat the water and seem
like less hot water.

• If you cannot find what is wrong, call the Sears Service Center.

WATER IS TOO HOT

• The temperature adjustment dial may be set coo high. See the

“Temperature Adjustment” section,

NOTE: A period of time is necessary after an adjustment
has been made for the water temperature to reach the new
temperature setting.

• If lower temperature settings will not lower the water tempera­

ture, call the Sears Service Center.

AWARNING

Due to the nature of the typical gas water heater, the
water temperature in certain situations may be hotter
than the thermostat setting.
Short, frequent draws of hot water - especially with very
cold incoming water - can shock the thermostat into brief
operation resulting in hotter and hotter layers of water
closer to the top of the tank.
Changes in hot water usage patterns or raising the tem­

perature differential between the cut-on of the thermo­

stat and the cold water temperature will usually eliminate
the problem.

24

Advertising
This manual is related to the following products: