Kenmore 790-.9663 - Manual (Page 46)

Generai Care & Cleaning
• Changing Oven Lights
• Care & Cleaning of Stainless Steel (some models)
Changing Oven Lights
ii^CAUTION Be sure the range is unplugged and all parts are COOL
before replacing oven light. Wear a leather-faced glove for protection
against possible broken glass.
The oven lights automatically turn ON when the door is opened. The oven
lights may also be manually operated by pressing the pad.
The upper oven light bulbs are located at the rear of the oven cavity and
both are covered with a glass shield. The glass shield must be in place
whenever the oven is in use.
Replacing the upper oven interior light bulbs:
1. Turn electrical power off at the main source or unplug the range.
2. Remove upperoven interior light shield as illustrated below.
3. Replace bulb with a new T-4 type 40 Watt Halogen appliance bulb. Please note: do not allow your fingers to touch the
new bulb when replacing. This will shorten the life of the new bulb. Use a paper towel to cover the new bulb when
installing.
4. Replace glass shield over bulb.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock will then need to be reset.
Care & Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions.
46