Kenmore 116.31913 - Manual (Page 15)

DUST BAG CHANGIN
TO REMOVE DUST BAG
WARNING
Always unplug power cord from
electrical outlet before performing
any service on vacuum.
Pyli out on the
bag cover release
located near the
top of the bag
cover
Bag Cover
BeieasB
Bag
Bag
Cover
Grasp the dust bag
collar and pull gently
carefully removing
the dust bag.
Throw away the used
dust bag.
Do not reuse.
Pull the bag
cover forward
and lift up
Remove and lay
aside
mi I
Bag Holder
Bag Cavity
Motor
Safety
filter
Dmt
Bag
Check the bag
holder and the
motor safety fil­
ter. If either is
blocked, check
TOr^l IDI C
I irv/UK/Lrw“
SHOOTING.
!1 CAUTION
NEVER REUSE A DUST BAG. Very
tine materiais, such as carpet fresh­
ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu­
uming these materials.
TO REPLACE DUST BAG
Dust
Bag
Safety
Seal Tab
Unfold the new
dust bag. Fold
the safety seal
tab on the new
dust bag away
from the open
ing that fits on
the bag holder.
NOTE: See PARTS AND FEATURES for
bag number
Insert the dust bag
onto the bag holder
completely by holding
the bag collar
Place the dust bag
collar into position.
Tuck the bag
behind each of the
four bag retention
corner flaps shown
here. Be sure the
bottom and sides
of the dust bag are
compietely within
bag cavity prior to
replacing the bag
cover.
Bog
Retention
Corner
Flaps
Position the bag
cover so its posi­
tioning tabs fit
into the body
positioning tab
slots.
Close the bag
cover.
You will hear a
distinct snap
when cover is
securely closed.
Bag
Cover
Check to see that the dust bag is fully
enclosed in the bag cover.
ПФ