Releasing the handle, Handle mounted, Pile height selection and setting – Kenmore 116.31913 User Manual
Page 7: Caution, On/off swit handle mounted, Some models
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RELEASING THE HANDLE
Release the handle by pressing down on
the handle release pedal with your foot and
pulling back and down on the handle with
your hand,
Note:
The agitator will not rotate if the vacu
um cleaner is in the upright position.
ON/OFF SWIT
HANDLE MOUNTED
SOME MODELS
To start the vacuum cleaner, slide the
On/Off switch from the OFF position to the
ON position. To stop the vacuum cleaner,
slide the On/Off switch to the OFF position.
Note:
This switch operates the suction
motor only. For the agitator to rotate, the
agitator On/Off selector must be in the ON
position and the handle must be released
from the upright position.
PILE HEIGHT SELECTION AND SETTING
To select a pile height setting:
Turn off cleaner. Select a pile height setting
by tilting the cleaner back until front wheels
are lifted slightly off the floor.
Slide the adjustment lever to the correct set
ting.
There are four (4) pile height settings on the
vacuum. Use the LOW setting for most car
pets and bare floor cleaning (with agitator
OFF), and the
HIGH
setting for very long
pile carpets like shag carpet, scatter rugs,
etc. Use the other settings as needed for
carpet heights in-between,
Height
Adjustment
Lever
A
CAUTION
Do not allow vacuum cleaner to
remain In one spot for any length of
time when the agitator is turning.
Damage to carpet may occur.