Kenmore 580.5245 - Manual (Page 6)

OPERATION
CONTROL PANEL
Your dehumidifier control panel contains a Bucket Full indicator, a Humidity indicator, a Power
Control, Humidity Control, Fan Speed Control and Timer Control.
Bucket Full indicator —This light glows when the water bucket is full and needs to be emptied.
Power — Operation starts when this button is pressed and stops when the button is pressed again.
Humidity Control — This button controls the humidity in the room.
• : To raise the humidity setting
• V : To lower the humidity setting
• The humidity can be set within a range of 40% RH(Relative Humidity)~70%
RH(Relative Humidity) by 5% increments.
Fan Speed — This controls the speed of the airflow.
• High; Fan speed is set to high.
• Low: Fan speed is set to low.
• When Fan Speed button is pressed, the fan speed mode is changed.
Energy Timer — Pressing this button will make the unit go into automatic On/Off mode. In this mode the unit
will be On for 3 or 6hrs and then it will automatically turn off for 3 or 6hrs.
After that it will turn on again and this cycle will be repeated continuously.
(Constant button will make the unit run continuously under normal humidity conditions.)
• The Timer can be set for: Constant, 6 Hr. On/Off or 3 Hr. On/Off.
• When Timer button is pressed, the Timer indicator lights shift as follows;
Constant 3 Hr. On/Off -> 6 Hr. On/Off Constant
Ayto Restart — In case the power comes on again after a power failure. Auto Restart Operation is the
function to operate procedures automatically to the previous operating conditions.
So there is no need of activating this function by pressing any key or button.
TO OPERATE THE DEHUMIDIFIER:
1. Plug the power cord into an electrical outlet. Press the power button.
2. Set the Humidity Control anywhere between 40% RH(Relative Humidity) and 70% RH(Relative Humidity)
for normal operation.
If you need drier air, press the v Humidity Control button.
If you need less moister air, press the л Humidity Control button.
3. Press the Power button to stop the unit manually.
4. Press the Timer button to set the amount of time you want the unit to run.
At the end of that time, the unit will shut off.
The Timer can be set f o r ; Constant 6 hours or 3 hours.
5. If you want to control the speed of airflow, press Fan Speed button. Each time that the Fan Speed button
is pressed, the fan speed mode is shifted: High -> Low High
Note: Be careful not to lose the water bucket.
This dehumidifier doesn’t run if the water bucket is not installed properly.
- 6