Preparing the faucet, Connecting your dishwasher – Kenmore 665.17425 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5.
Push door firmly closed. The door latches
automatically. Run hot water at the sink where you will
connect dishwasher until water is hot. (See
“Dishwasher Efficiency Tips.”) Turn off the water and
hook the dishwasher to the faucet. (See “Connecting
Your Dishwasher.”) Turn on the hot water.
6. Press the desired cycle and option selections. (See
“Using Your Dishwasher”) Turn the Cycle Control knob
to the desired cycle to start.
CONNECTING YOUR
DISHWASHER
NOTE:
A special adapter must be installed on the faucet
before the dishwasher can be connected. Complete
Installation Instructions and the adapter are packed with
your dishwasher. (See the Installation Instructions).
When moving your dishwasher make sure the door is
latched. Hold the dishwasher at the top front corners.
Preparing the faucet
1. Remove the screen holder or aerator, screen,
washer from the end of the faucet.
and
2. Use the faucet adapter kit that came with your portable
dishwasher to modify the faucet where the dishwasher
will be used.
1
2
3
1. Washer
2. Screen
3. Screen holder or aerator
NOTE:
Remove and save the washer, screen, and screen
holder or aerator for future use.
Connecting the faucet adapter to faucets with
external threads
Insert the two screens and then the thin washer from the
faucet adapter kit into the faucet adapter. Attach the
adapter onto the end of the faucet.
1
2
3
1. Thin washer
2. Screens
3. Faucet adapter
NOTE:
Do not use the thick washer.
8