Kenmore 665.17425 - Manual (Page 9)

Connecting the faucet adapter to faucets with
internal threads
Insert the 2 screens, the thin washer, and then the thick
washer from the faucet adapter kit into the faucet adapter.
Attach the adapter onto the end of the faucet.
1
2
3
4
1. Thick washer
2. Thin washer
3. Screens
4. Faucet adapter
NOTE: Use both washers.
You can draw water from the faucet while the dishwasher
is connected.
NOTE: Do not draw water while the dishwasher is filling or
while water is being pumped out. (This helps prevent a low
fill when dishwasher is filling or mixing drain water with
fresh water when dishwasher is draining.)
Press the red button on the hose connector to draw water
from the faucet. (The faucet is set on hot. Adjust the faucet
for the water temperature you want.)
NOTE: Turn the hot water back on after you draw water
from the faucet. Turn off the cold water.
1 . Run water at the faucet until it is hot. Turn the water off.
2. Pull the hoses out of their storage compartment on the
back of the dishwasher.
NOTE: Make sure the hoses are not kinked or twisted.
Kinked hoses reduce washing performance.
3. Pull down on the locking collar while lifting the hose
connector onto the faucet adapter.
1. Faucet adapter
2. Locking coilar
3. Hose connector
4. When the connector snaps into place, release the
locking collar.
5. Turn the hot water on slowly until it is all the way on.
6. Plug into a grounded 3 prong outlet.
1. Turn the hot water off. (This can be done after the last
rinse.)
2. Press the red button on the connector to release the
water pressure.
1
2
3
4
1. Faucet adapter
2. Locking coliar
3. Red button
4. Hose connector
3. Lift slightly on the hose connector while pulling down
the locking collar. Pull down on the connector.
4. Empty any remaining water from the connector by
turning the connector upside-down.
5. Unplug the power supply cord and return it to the
storage compartment.
6. Return the hoses to the storage compartment.