Caution: bevvare of flashback, Figure 1, Flashback prevention – Kenmore ELITE 141.17691 User Manual

Page 5: Tools required for assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CAUTION:

bev

VARE OF FLASHBACK

CAUTION: Spiders and smaii insects occa­
sionally spin webs or make nests in the gril!

Burner Tubes during transit and warehousing.

These webs can lead to a gas fiow obstruc­
tion which couid result in a fire in and around
the Burner Tubes. This type of fire is known
as a "FLASHBACK" and can cause serious
damage to your grili and create an unsafe
operating condition for the user.

To reduce the chance of "FLASHBACK", you
must clean the burner tubes before assem-
biing your grill, and at ieast once a month in
late summer or early fail when spiders are
most active. Also perform this Burner Tube
cleaning procedure if your grill has not been
used for an extended period of time.

Figure 1

Flashback Prevention

To reduce the chance of "FLASHBACK" (see

CAUTION at left) clean the Burner Tubes and
Burners before fully assembling your grili.
Remove the Cotter Pin from the rear underside

of each Burner using a pair of long nose pliers.

Carefully lift each Burner up and away from the
Gas Valve Orifice, then refer to Figure 1 and
perform one of these three cleaning methods:

1

.

Bend a stiff wire, (a lightweight coat hanger

works well) into a small hook as shown
below. Run the hook through the Burner Tube
and inside the Burner several times to remove
any debris.

c

2

.

3.

Use a bottle brush with a flexible handle.

Run the brush through the Burner Tube and
inside the Burner several times, removing any
debris.

Use an air hose to force air through each

Burner Tube. The forced air should pass
debris or obstructions through the Burner and
out the Ports.

GAS COLLECTOR BOX

A

warning

The location of the Burner Tube with re­
spect to the Orifice is vital for safe opera­
tion. Check to ensure the Orifice is inside
the Burner Tube before using your gas grill.
See Figure 2. if the Orifice is not inside
the Burner Tube, lighting the Burner may
cause explosion and/or fire.

Figure 2

Tools Required for Assembly

• #2

Phillips

screwdriver

• Protective work gloves
• Eye protection
• Utility knife

Advertising
This manual is related to the following products: