Leak testing valves, hose and regulator, Immediately, Rushing sound – Kenmore 415.16218 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6
.
Turn the coupling nut clockwise and tighten to a full stop. The
regulator will seal on the back-check feature in the LP tank
valve, resulting in some resistance.
An additional one-half to
three-quarters turn is required to complete the
connection. Tighten by hand only - do not use tools.
NOTE:
If you cannot complete the connection, disconnect regulator and
repeat steps 5 and 6. If you are still unable to complete the
connection,
do not use this regulator!
Do not insert any foreign objects into the valve outlet. You
may damage the valve and cause a leak. Leaking propane
may result in explosion, fire, severe personal injury, or
death.
Never attempt to attach this grill to the self-contained LP gas
system of a camper trailer or motor home.
Do not use grill until leak-tested.
If a leak is detected at any time, STOP and call the fire
department.
If you cannot stop a gas leak,
immediately
close LP tank
valve and call LP gas supplier or your fire department!
Leak Testing Valves, Hose and Regulator
1. Turn all grill control knobs to OFF.
2. Be sure regulator is tightly connected to LP tank.
3. Completely open LP tank valve by turning OPD hand wheel
counterclockwise. If you hear a
rushing sound,
turn gas off
immediately. There is a major leak at the connection.
Correct
before proceeding.
4. Brush soapy solution onto areas where bubbles are shown in
picture below;
▲ Never remove threaded
orifice at end of valve.
■
^ ^
Sideburner
Valve
5. If “growing”
bubbles appear, there is a leak. Close
LP
tank
valve immediately and retighten connections.
If leaks cannot
be stopped do not try to repair.
Cali Sears for replacement
parts at
1-800-4-MY-HOME®
6
.
Always close LP tank valve after performing leak test by
turning hand wheel clockwise.
403845504-19