Ignitor lighting, Match-lighting, Ignitor lighting the sideburner – Kenmore 415.16218 User Manual
Page 21: Match lighting, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CAUTION
Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety reasons.
Do not use water on a grease fire. Personal injury may
result. If a grease fire develops, turn knobs and LP tank
off.
Do not leave grill unattended while preheating or
burning off food residue on high. If grill has not been
regularly cleaned, a grease fire can occur that may
damage the product.
Ignitor Lighting
A
Do not lean over grill white lighting.
1. Open lid.
Turn on gas at
LP
tank.
2. Turn left knob to @ (ignite position).
3. Push and hold ignitor button to light. Be sure burner lights and
stays lit.
4. If burner does not light, turn knobs to , wait 5 minutes,
try again.
5.
Once left burner is lit, turn right knob to 0 to light right
burner.
6
.
If ignitor does not work, wait 5 minutes, then follow match
lighting instructions.
After Lighting:
Turn knobs to HI position for warm-up. Do not
warm up grill with knobs on # (ignite position). Knobs and
handle will become uncomfortably hot if left in # (ignite
position).
CAUTION
if burner does not light, turn knobs to^B. wait 5
minutes, and try again. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidentally ignite with risk of injury.
Match-Lighting
A
Do not lean over grill while lighting.
1. Open lid.
Turn on gas at
LP
tank.
2. Place lit match into match-lighting hole from beneath grill
bottom (as shown below).
3. Push in and turn right knob to H (ignite position). Be sure
burner lights and stays lit.
4. Light left burner by pushing left knob in and turning to 0
(ignite position).
After Lighting:
Turn knobs to
HI
for warm-up.
Match-lighting hole is
beneath grill bottom.
Ignitor Lighting The Sideburner
ITurn on gas at LPtank.
2. Push in and turn sideburner knob to HI.
3. Press and hold ignitor button to light. Be sure burner lights and
stays lit.
4. If burner does not light, turn sideburner knob to
OFF,
wait 5
minutes, try again.
Match Lighting
1. Turn on gas at LP tank.
2. Hold a lit match to any port on the sideburner. Push in and
turn the sideburner knob to
Hi.
Be sure burner lights and stays
lit.
403845504
*
21