Side burner lighting instructions, Back burner lighting instructions, Warning – Kenmore 141.173373 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

7.

8

.

10

.

Immediately press the left Electric ignitor for
3-4 seconds to light the Burner.

LEFT ELECTRIC
IGNITOR

If the Burner does not light, turn the Control Knob

to OFF, wait 5 minutes for gas to clear, then
retry.

Once the grill burner is ignited, the adjacent
Burner can be lit by simply turning its Control
Knob to HIGH.

Adjust Control Knobs to your desired cooking
temperature.

Side Burner Lighting Instructions

1.

Follow steps 1 through 5 of the Basic Lighting
Procedures.

4.

Open the Grill Lid. Failure to do so can result in
fire or explosion. See WARNING below.

A

WARNING

Failure to open Grill Lid during the
lighting procedures could result in a fire

or explosion that could cause serious

bodily injury, death, or property damage.

5.

Set ALL Control Knobs to OFF and open the LP
Gas Tank Valve slowly until 1/4 to 1/2 open.

Open LP
Gas Tank

Push and turn the Control Knob (on the right Side
Burner Frame) for Side Burner to HIGH.

OFF

RIGHT ELECTRIC

SGNITOR
(for SIDE BURNER)

3.

immediately press the Right Electric Ignitor for 3-4

seconds to light the Burner.

4.

If the Burner does not light, turn the Control Knob

to OFF, wait 5 minutes for gas to clear, then retry.

5.

Adjust Control Knobs to your desired cooking
temperature.

Back Burner Lighting Instructions

Note: The location of the Back Burner makes it more
susceptible to winds that will decrease the perfor­
mance of your rôtisserie cooking. For this reason you

should not operate the Back Burner during windy
weather conditions.

1. If you have a LP Gas grill be sure the LP Gas Tank

is filled, or if you have a NG grill be sure that the
locking shut off valve is open.

2. Check that the end of each Burner Tube is

properly located over each Valve Orifice.

3. Be sure all gas connections are securely tightened.

6. Push and turn the Right Control Knob for Back

Burner to HIGH.

T

HI

immediately press the Right Electric ignitor

for 3-4 seconds to light the Back Burner.

RIGHT

ELECTRIC

IGNITOR

8

.

If the Burner does not light, turn the Control Knob

to OFF, wait 5 minutes for gas to clear, then retry.

9

. Once lit, the Back Burner will reach cooking

temperature quickly. The orange/red glow will
even out in about 5 minutes.

10. For best results, always rôtisserie cook with the

grill lid down and the Back Burner Control Knob set
to ON. Do not use the Main Burners when the

Back Burner is in operation.

25

Advertising
This manual is related to the following products: