Se c t i, Water softener start up, A. safety guides – Kenmore 625.38816 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

J J jjajij J JJ J J JJ J J JJ J J J J J J J

JJ J jjj J J J jjj J J J J jjj J J JJ JJ

jjjjjjjJJjjjjjjjjjjJJJJJJ

SECTION 1

= J JJ J JJJJJJJ JJJJJJJ jjj

iJjJJJJJJJJJJJJJJJJJJJJJJ

î j j j j J J j j j j j j j j j ,

WATER SOFTENER START UP

S

E

C

T

I

o

N

ijjjjjjjJJJJJJJJJJ

ijjjjjjjjjjjjjjjjj

IJJJJJJJJJjJJJJJJJ
IJJJJSJ JJJJJ JJJJJ

ijj

J^B

jjjjjjjjjjj

JJJJA

j

J

JJJJJ

JJJJ

IJJJJBJ JJJJJ

jjjjj

IJJ

jj

9

jj

JJJJJJJ jj

FJJJJA

j

JJJ

JJJJJJJ

IJJ

jj

J9

jj

JJJJJJJJJ

IJJJJJJJJJJJJJJJJJ

IJJJJJJJJJJJJJJJJJ

IJJJJJJJJJJJJJJJJJ

A. SAFETY GUIDES

A Read all steps, guides and rules carefully before

Installing and using your new water softener. Follow

all steps exactly to correctly install. Failure to follow
them could cause personal injury or property damage.

Reading this book will also help you to get all of the
benefits from your water softener.

A Your water softener will remove hardness minerals
and “clear water” iron* from water, up to the limits
shown on page 4-1. It will not remove other types of
iron, acids, tastes and odors, etc. It will not purify pol­
luted water or make it safe to drink.

A Protect the softener and piping from freezing. Dam­
age from freezing voids the softener warranty. See

page 3-3.

CAUTIONS

PLEASE READ AND COMPLY WITH THE FOLLOWING

GUIDES TO PREVENT DAMAGE TO THE SOFTENER
OR OTHER PROPERTY, PERSONAL INJURY, OR

POSSIBLE FATAL SHOCK.

A THIS SOFTENER WORKS ON 24 VOLTS ONLY. BE
SURE TO USE ONLY THE TRANSFORMER IN­
CLUDED, AND PLUG IT INTO A NOMINAL 120V, 60

CYCLE HOUSEHOLD OUTLET THAT IS GROUNDED
AND PROPERLY PROTECTED BY AN OVERCUR­
RENT DEVICE SUCH AS A CIRCUIT BREAKER OR

FUSE. IF TRANSFORMER IS REPLACED, USE ONLY

THE AUTHORIZED SERVICE, CLASS II, 24 VOLT, 10
VA TRANSFORMER.

A Unplug the transformer right away if the power

cable should become damaged or frayed. Make re­

pairs, or replace transformer, before plugging back
into the power outlet.

A Always unplug the softener from electrical power

before removing outer valve covers.

A This system is not intended to be used for treating

water that is microbiologically unsafe or of unknown

quality without adequate disinfection before or after

the system.

* Capacity to remove clear water iron was tested in the
field by the manufacturer.

1 -1

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line

Advertising
This manual is related to the following products: