Kenmore 580. 72089 - Manual (Page 7)

__ Select the position that wilt place the sill supports
near the outermost point on sill (FIG. 10)
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
FIG. 10
Place the sill supports with the cabinet on the
window sill's selected position.
The cabinet should be installed with a very
slight tilt (about 1/4") downward toward the outside
(FIG. 11).
Adjust the bolts and the nuts of sil! supports to level
the cabinet.
screws (ITEM F) through the front angle into the
window inner sill (FIG. 12).
Pul! each side curtain fully to each side of
window opening.
Attach each side curtain to the window sash using
screws (ITEM G), (FIG, 13)
Attach the i BRACKET (ITEM J) with screw
ТЕМ G). (FIG. 14)
0e sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight tilt
downward to the outside for proper water drainage.
The air conditioner will drain the excess condensed
water through the drain pipe, (FIG. 15)
BASE PAN REAR
DRAIN PIPE
BASE PAN BOTTOM
FIG. 15
Slide the chassis into the cabinet (FIG. 16)
CAUTION: For security purposes, reinstall side
screws you removed in step 1.
Cut the foam strip (ITEM H) to the proper length
and inserí between the upper window sash and the
lower window sash. (FIG. 17)
I The vent control handle must be straightened