Remote control, Power л, Temperature setting – Kenmore 580.75080 User Manual
Page 11: Timer, Mode, Operation, How to insert batteries into remote control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
REMOTE CONTROL
NOTE: The Remote Control will not operate properly if strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote Control and the Air Conditioner.
Every time you push button, you will hear a beep from the Air Conditioner.
POWER ------------------------------------------------------------------------------------------------Л
• To turn the air conditioner ON, push this button. To turn theair conditioner OFF, push the
button again. This button takes priority over any other button.
When you first turn it on, the air conditioner is on the High cool mode and the Temp at
70°F
TEMPERATURE SETTING
Use these buttons to automatically control the temperature of the room.
The temperature can be set within a range of 64°F to 82°F.
Push the TEMP up or down buttons to shift the temperature setting from
32°
f
^76°F^70°F^64°F
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running. Use Timer to set the number of hours until shut-off.
• Push Timer buttons to advance the Timer setting as follows:
1 Hour(1 Hour-2 Hours)^ 3 Hours(3 Hours-5 Hours)► 6 Hours(6 Hours-9 Hours)
► 10 Hours maximum.
- START TIME
• If unit is off. Use the Timer to set the number of hours before unit starts .
• Push Timer buttons to advance the Timer setting as follows :
1 Hour(1 Hour-2 Hours)^ 3 Hours(3 Hours-5 Hours)► 6 Hours(6 Hours-9 Hours)
► 10 Hours maximum.
MODE -------------------------------------------------------------------
• Push this button to shift the mode of operation from:
COOL-HI ► COOL-LOW ► FAN ONLY-HI ► FAN ONLY-LOW.
HOW TO INSERT BATTERIES INTO REMOTE CONTROL
1. Remove the cover from the back of the remote
controller.
• Open the cover according to the arrow direction on the
cover.
2. Insert two batteries.
• Be sure that the (+) and {-) directions are correct.
• Be sure that both batteries are new,
3. Re-attach the cover.
' Do not use rechargeable batteries.
Such batteries differ from standard dry cells in shape,
dimensions, and performance.
‘ Remove the batteries from the remote controller if the air
conditioner is not going to be used for an extended
length of time.