Kenmore 7881 - Manual (Page 9)

Oven Control Functions
READTHEINSTRUCTIONSCAREFULLYBEFOREUSlNGTHEOVEN.Forsaiisfactoryuseofyouroven.becomefamiliarwith
the various pad functions of the oven as described below.
CLOCK SET
PAD—
Used
to set the
time of day.
COOK TIME
PAD
— Used to
enter the length of
the baking time.
FEATURE
INDICATOR
LIGHTS— These
light to show
which feature is
OVEN INTERIOR
LIGHT PAD—
Used to
turn oven interior light
ON or OFF. This pad is
also used to activate
the Cooktop Lockout
feature (some models).
SELECT SELF-CLEAN
PAD— Used to select
the Self-Cleaning ^
cycle. A 2, 3 or 4 hour
Self-Clean time may be
selected.
UP and DOWN ARROW PADS—
Used along with the function pads to
select oven temperature, cook time,
start time (when programming an
automatic start time), time of day,
clean time and minute timer.
ADD 1 MINUTE —
Use to select Add 1
Minute feature.
88'8
i
® Övee
® Ociijr Uiisksfl
® Cmikmp Lfieksij
BAKEPAD—
Used to select
the bake
function.
BROIL PAD— Used to
select the variable broil
function.
SLOW COOK PAD—
Used to set the Slow Cook
feature.
WARM & HOLD PAD—
Used to set the Warm &
Hold feature.
RECIPE RECALL PAD—
Used to set the Recipe
Recall feature.
TIMER SET/OFF DELAY START OVEN, PREHEAT & DOOR LOCKED LIGHTS* —The "OVEN" STOP/CLEAR PAD-
PAD — Used to set or PAD — Used to light will glow each time the oven turns on to maintain the set Used to clear any
cancel the minute set the desired oven temperature. The "PREHEAT" light will glow when the function previously
timer. The minute timer start time for oven is first set to operate, or if the desired temperature is reset entered except the time
does not start or stop baking & Self- higher than the actual oven temperature. The "DOOR LOCKED" of day and minute timer,
cooking. Also, Clean. May be light will flash when the oven door locks and unlocks or when Press STOP/CLEAR to
TIMER SET/OFF pad used with COOK using the Self-Ciean cycle or the oven door lockout is activated, stop cooking. Also the
is used to set the TIME to program The indicator light will glow constantly after the door STOP/CLEAR pad is
Continuous Bake a delayed bake locks.COOKTOP LOCKED light will glow when the cooktop has used to activate oven
feature. cycle. been locked (some models). door lockout setting.
*Note: The OVEN indicator light on the electronic display will once to change back to normal sound mode (:SP will
turn ON and OFF.when using the Bake feature and during .
preheat. This is normal and indicates that the oven is cycling
appear in the dispiay). The control will now provide normal
to maintain the selected baking temperature. When the V audible beeps whenever a pad is pressed.
preheat indicator light turns OFF, your oven is ready. Temperature conversion
For a silent control panel The electronic oven control is set to operate in °F (Fahrenheit)
When choosing a function, a beep will sound each time a pad ""en shipped from the factory^The oven can be programmed
is pressed. If desired, the control can be programmed for silent temperature from 170“F to 550“F (77°C to 287°C).
operation. To switch back and forth between normal sound or
silent operation' To change the temperature to °C (Celsius) or from °C to °F
(control should not be in a Bake or
Clean mode):
Press & hold tey. After 7 seconds, the control will beep once.
1. Press . "------------- " appears in the display.
:SP should appear in the display indicating that the control is in
normal sound mode. Press either or N«'’ once to change 2. Press and hold the W until "HI" appears in the dispiay.
to silent mode - will appear in the display). The silent mode
will block the controls from sounding when a pad is pressed.
Press and hold ^ until °F or °C appears in the display.
To return to normal sound operation, press & hold (S). After 7 4. Press the vV or 'V' to change °F to °C or °C to °F.
^ 5. Press any control pad to return to normal operating mode,
seconds - will appear in the dispiay. Press either y\ or
................................................................................................................................................................................................................................................................................................ i..........................................
Setting Oven Controls
Note: The time of day must first be set in order to operate the oven, i 'v.................:..(:..(:..(:..(:..(: ; ( :
To Set the Clock
2 . Within 5 seconds, press and hold the W or until the
When the range is first plugged in, or when the power supply to
the range has been interrupted, the display will flash "12:00".
correct time of day appears in the display.
©
Note: The clock cannot be changed during any timed bake
once (do not hold pad down). or Self-Clean cycle.
9
T
r'
.kbvub
y: .