Soft water service and regeneration, Electronics – Kenmore 625.3486 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SECTION 2

HOW YOUR WATER SOFTENER WORKS

2B.

SOFT WATER SERVICE AND REGENERATION

AUTOMATIC BYPASS

During the brining, brine rinse and backwash
cycles of regeneration, HARD water goes through
the softener valve and to the house pipes. If a faucet
is opened, hard water is there for your needs.
However, you should not use hot water, if possible,

because the water heater will refill with hard
water. The softener, as factory programmed, regen­

erates from 2:00 AM to about 4:00 AM, a time when
not much water is used.

If you get up early in the morning and you can hear
the softener regenerating, change the recharge
starting time. Set the recharge time to 12:00 AM or

1:00 AM (page 7). Then regeneration will start and
end that much earlier and your water heater will

not refill with hard water if a hot faucet is opened.

ELECTRONICS

Two main parts of the softener's electronics are [T] a
WATER METER, and [3 a COMPUTER.

H] WATER METER — The water meter is in the

softener valve outlet. As water flows through the
meter, it sends electric pulses to the computer. The
computer changes the pulses to a measure in
gallons of water.

¡2} COMPUTER — The computer is part of the

faceplate timer circuit board. It is programmed to
know the softener's capacity (how many grains of
hardness minerals it will take out of the water
before a regeneration is needed). When starting the
softener, page 7, you set it for the grains per gallon

(gpg) hardness of the water.

To find a regeneration pattern best for your needs,
the computer uses: (1) water usage from the meter,
(2) hardness setting, (3) softener capacity, and (4)
time since the last regeneration. The computer
always adjusts this pattern to your water using
habits. It works toward providing you with soft
water for the longest time and at the most efficient
salt usage.

Softening capacity is used as hard water goes
through the softener and hardness minerals are
removed. When the computer determines that
only enough capacity remains to provide soft
water up to the next regeneration starting time
(2:00 AM, or as otherwise set) it will schedule a
regeneration. RECHARGE TONIGHT displays un­
til the regeneration begins. When the regeneration

begins, TONIGHT goes off and *RECHARGE or
RECHARGE TIME REMAINING flashes during
the 2 hour regeneration.

=^NOTE:

If the CLEAN feature is set to ON, a cleaning
backwash {CEEAN and Bkwsh or Rinse flashes in
the display, along with the minutes of the clean
cycle remaining), precedes the recharge.

14

Advertising