Kenmore ULTRA WASH 665.1404 - Manual (Page 18)

P Selecting Cycles and Options
I
I Touch the desired cycle icon in the carousel screen to select a cycle. The options become available for each cycle adjacent to the
I selected cycle. Press and hold a cycle or option icon to access descriptions. In order to return to the carousel screen from the descriptions,
I press the X. The screen will go to standby after a number of minutes without activity. In order to wake up the control, slide your finger
I across the center of the screen.
The i icon in the upper right-corner of the screen gives access to the information section. This window will give access to Getting Started, |
Cycles and Options, Helpful Hints, and Troubleshooting. In Getting Started, you can access a tutorial showing how to use the touchscreen. I
. . . . . P
To return to running mode, open the door and end the tutorial. Helpful Hints vj'M be displayed after a cycle to help you use the p
dishwasher efficiently. In order to return to the carousel screen, touch the gear icon. I
Settings Icon
The gear icon in the upper left-corner of the screen gives access to the settings. In the settings window, the Language, Time, Volume,
Brightness, and Helpful Hints activation can be adjusted. In this section. Volume and Helpful Hints can be turned ON and OFF. The
Factory Recommended Options can be reset; Installation Setup can be accessed. In order to return to the carousel screen, touch the gear
Delay Hours (on some models)
I Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak hours when
I possible.
To delay the start
1. Press CLOCK icon, then drag the slider to adjust the start or end time of the cycle.
2. Press START/RESUME and fi rmly close the door within 3 seconds.
I NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again, within 3
I seconds of closing the door, to resume the delay countdown.
*To set Time of Day clock, press the settings icon (gear icon) and select Time.
wxmmismmm.
I
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles.
To turn on the Lock
I Press and hold the LOCK icon for 3 seconds to lock the control. When locked, the touchscreen is disabled until the lock icon is pressed
I
and held for 3 seconds.
I NOTE: The dishwasher door can still be opened/closed while the controls are locked.
I
I To turn off the Lock
i Press and hold the CONTROL LOCK for 3 seconds. The light turns off.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.
3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the
dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before
restarting your new cycle.
3. Press Cancel/Drain twice to reset the control.
4. Select new cycles and options.
5. Press START/RESUME and firmly close the door within 3 seconds.
18