Cleaning method, A warning – Kenmore 640-82960819-9 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Then loosen but do not remove the upper two
screws above the light.
7. Pull out the light bulb and replace with a new
bulb. Tighten the four screws.
Note:
Do not touch the halogen bulb with bare hands.
8. Replace glass cover, reinsert light bulb housing into
the grill, and insert and tighten the screw.
Cleaning Method
Follow steps 1 through 4 above for glass cover removal. Use a damp towel to clean the surface of the
glass cover. Make sure the glass cover is completely dry before re-installing.
A
WARNING
Make sure the light switch is in the “OFF” position and the power plug is disconnected from the
power outlet prior to cleaning the glass cover.
A
WARNING
The glass cover should not be in contact with water or any other liquid when it’s warm. Sudden
change of temperature may cause cracks in the glass.
A
WARNING
To ensure continued protection against electric shock:
1. Connect to properly grounded outlets only.
2. Do not expose to rain.
3. Keep extension cord connections dry and off the ground.
Bulb Type: Halogen
Wattage: 10 watts per bulb
Voltage: 12 volts
ff you still have questions about replace bulb, call the
Customer Service Helpline 8 AM - 5 PM
PST, Monday through Friday at 1-800-913-8999.
13