Kenmore POWER MISER 153.320390 HT 30 GAL - Manual (Page 12)

Installation Instructions (contad)
Converting the Lower
Element (cont’d)
9. Tighten terminals 2 and 3 to ensure proper electrical
connection.
AWARNING
Failure to tighten terminal screws can cause a fire which
can result in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
10. Replace terminal cover on the thermostat, making sure the
notch is in place over the tab.
Q
lUH oír
m&t
AWARNING
Make sure the thermostat is flush against the tank, the
terminal cover is in place, and the insulation is replaced.
Failure to do so can result in DEATH, SERIOUS BODILY
INJURY, OR PROPERTY DAMAGE.
11. Fold the insulation back in place so that it completely covers
the thermostat and element.
12. The adjustment dial has a “D” shaped opening that matches
a “D” shaped shaft on the thermostat. Align die opening in
the dial to the shaft and gently push the dial onto the shaft.
o
-war
(ft)
13. Replace the access panel.
14. Complete wiring to the water heater, or if completed, turn
“ON” electric power to the water heater after filling the
tank with water.
A CAUTION
Never use this water heater unless it is completely full of
water. To prevent damage to the tank and heating ele­
ment, the tank must be filled with water. Water must
flow from the hot water faucet before turning “ON”
power.
12