Kenmore POWER MISER 153.320390 HT 30 GAL - Manual (Page 7)

Installation Instructions (cont’d)
Facts to Consider About the
Location
You should carefully choose an indoor location For the new
water heater, because the placement is a very important consid­
eration for the safety of me occupants in the building and for
the most economical use of the appliance. This water heater is
not intended for outdoor installation.
Whether replacing an old water heater or putting the water
heater in a new location, the following critical points must be
observed.
• The location selected should be indoors as close to and as
centralized with the water piping system as possible. This
water heater, as well as all water heaters, will'eventually leak.
Do not install without adequate drainage provisions where
water flow will cause damage. .
A CAUTION
WATER HEATERS EVENTUALLY LEAK: Installation of
the water heater must be accomplished in such a manner
that if the tank or any connections should leak, the flow of
water will not cause damage to the structure. When such
locations cannot be avoided, a suitable drain pan should
be installed under the water heater. Drain pans are avail-
abie at your iocal Sears stores. Such a drain pan must be
piped to an adequate drain. Under no circumstances is
the manufacturer or Sears to be heid iiabie for any water
damage in connection with this water heater.
A CAUTION
iNSTALLATION IN RESIDENTIAL GARAGES: The
water heater must be located and/or protected so it is
not subject to physical damage by a moving vehicle.
The location selection must provide adequate clearances for
servicing and proper operation of the water heater.
Facts to Consider About The
Convertible Lower Element
The Upper Element (if a double element model), is a conven­
tional 3800 watt element which only operates at its rated
wattle on 240 volts. (See rating plate on water heater).
The Lower Element of the water heater can be converted from
operation at 3800 watts to 5500 watts on a 240 volt system.
Read and follow water heater warnings and instructions. If after
reading these instructions in this manual, if you do not under­
stand any portion, call Sears Service Center.
AWARNING
Before making the conversion to 5500 watts, check the
(I) power supply...must be 240 volts, (2) wiring... 10 gauge
AWG @ type T.W. 60c or equivalent, and (3) Circuit
breakers or fusing...capable of 30 amp loading. Also, the
instaiiation must conform with this manual, local codes
and electric utility rules. Failure to comply can result in
DEATH, SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE.
VwCTORY EQWPPED WtTH
_____ ELECTRIC WATER HEATER
cofWHFrwmrr № ___
worn IMI HEAT 9 I H.-
w ert MËMTtON MOOa A
»OOCL»UyBEB
WATE
ECO
tHSTALUS)
SBUALtHIMHm
mm wem
omemLWATTAOE
UA QAL.
'a.B.....CHËCK(/)HERE'
150
WATTS A.c;o»fcl(:TFirldiÀLLy)ïs ■ PSJ.
' FACTORY EQUIPPED
UAMUUB CHECK!/) HERE ’
WARHINQ
SEE OONVERStON
INSTRUCTION
WATTS : IF CONVERTED: ;
NOTE: Whether or not the element conversion ts made the
model rating plate must be marked. Using a hard point ink
pen, check the appropriate block within the model rating
plate, which is located adjacent to the lower access panel.