Kenmore ELITE 721.86003 - Manual (Page 27)

CARING FOR THE FILTERS
The grease filters should be removed and cleaned often, at least once a month.
NOTE: If your microwave hood combination is installed to recirculate air, the charcoal
(Port No. 5230W1A0003A) is available from Sears by calling 1-800-4-MY-HOME®.
The charcoal filter cannot be cleaned and should be replaced every 6 to 1 2 months.
filter
Grease filfers (Part No. 2B72705B):
1. Unplug microwave oven or disconnect power.
2. To remove grease filters, slide each filter to
the side. Pull filters downward and push to the
other side. The filter will drop out.
3. Soak grease filters in hot water and a mild
detergent. Scrub and swish to remove
embedded dirt and grease. Rinse well
and shake to dry. Do not clean filters with
ammonia or corrosive cleaning agents such as
lye-based oven cleaners, or place them in a
dishwasher. The filters will turn black or could
be damaged.
4. To replace grease filters, slide filter in the
frame slot on one side of the opening. Push
filter upward and push to the other side to
lock into place.
5. Plug in microwave oven or reconnect power.
Charcoal filter replacement:
If your oven is vented inside, the charcoal filter
should be replaced every 6 to 1 2 months, and
more often if necessary. The charcoal filter cannot
be cleaned. Purchase a new charcoal filter from
the nearest Sears Parts & Repair Service Center,
or by calling 1-800-4-MY-HOME®.
1. Unplug microwave oven or disconnect power.
2. Remove the two vent grille mounting screws.
Slide the vent grille slightly to the left.
Vent Grille
3. Tip the grille forward; then lift out to remove.
4. Remove the old filter.
5. Slide a new charcoal filter into place. The
filter should rest at the angle shown.
6. Push the vent grille into place. Slide the grille
to the right until it snaps into place.
7. Replace the mounting screws.
8. Reconnect power or plug in microwave oven.
NOTE: Do not operate the hood without the grease filters in place.
27