Converting the lower element (cont'd), A warning, Installation instructions (cont’d) – Kenmore POWER MISER 153.32676 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Converting the Lower
Element (cont'd)
2.
The convertible element is located behind the lower access
panel of the water heater. Remove the two screws securing
the access panel, and remove panel.
Installation Instructions (cont’d)
5. Remove the screws from terminal 2 of the element, and move
the looped end of the wire aside.
3. Remove the insulation block and pad.
6. The buss bar is labeled 5500 W. Place the buss bar over termi
nals 2 and 3 with the 5500 W visible. Install the extra screw
provided into terminal 3.
4. Lower Element: Lift out the tab as shown to unclip the ter
minal cover from the thermostat. The terminal cover can be
removed from the thermostat.
7- d'he wire removed from terminal 2 has a looped end. It must
remain looped and now be placed (as shown) on top of the
buss bar, over the opening of terminal 2, and secured using
the remaining screw.
i. Tighten terminals 2 and 3 to ensure proper electrical
connection.
A WARNING
Failure to tighten terminal screws can cause a fire which
can result in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
11