To change the oven light, To adjust the oven temperature, Changing oven light – Kenmore 790.75503 User Manual
Page 36: Adjusting oven temperature
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing Oven
Light
A CAUTION
Be sure the oven is unplugged and all parts are COOL before replacing the
oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature
will reduce lamp life.
To Change the Oven Light
The oven light automatically turns on when the door is opened (some models). To turn the
oven light on and off when the door is closed, use the OVEN LIGHT switch located on the
control panel.
1. Turn electrical power off at the main source or unplug the oven.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Press wire holder to one side to release the glass shield.
4. Replace bulb with a new 40 watt appliance bulb.
5. Replace glass shield in socket and snap wire holder into place.
6. Turn power back on at the main source (or plug the appliance back in).
7. The clock will then need to be reset. To reset, see
Setting the Clock and Minute Timer
in
the ELECTRONIC OVEN CONTROL section of this manual.
Adjusting Oven
Temperature
NOTE:
The adjustments
made will not change the
self-cleaning temperature.
When first using the oven, be sure to follow recipe times and temperatures. If you think the oven
is too hot or too cool, the temperature can be adjusted. Before adjusting the oven temperature,
test a recipe by using a temperature set higher or lower than the recommended temperature.
The baking results should help you to decide how much of an adjustment is needed.
To Adjust the Oven Temperature:
1. Push
BAKE,
2. Set the temperature to 550°F/288°C by pushing the
UP ARROW.
3. Within 2 seconds, push and hold
BAKE
for approximately 5
seconds until the special 2 digit display appears. Release
BAKE.
The display now Indicates the difference in degrees between the
original factory temperature setting and the current temperature
setting. If the oven control has the original calibration, the display
will read "00",
4. The temperature can now be adjusted up or down 35°F/21°C, in
5°F/3°C increments, by pushing the
UP or DOWN ARROW.
Adjust until the desired amount of degrees offset appears in the
display. When adjusting for a cooler temperature, a minus sign (-)
will appear before the number in the display.
5. When you have made the desired adjustment, push
CLEAR OFF
to go back to the time of day display.
36