Kenmore 790. 4045 - Manual (Page 7)

Control Pad Features
Note: The appearance of your oven control may differ slightly from the one illustrated below. However, all functions are
the same. Also, push buttons or pads may be shaped differently than those appearing in this Use and Care Guide.
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become
familiar with the various functions of the oven as described below.
CLOCK SET
PAD
—Used to
set the time of
day.
TIMER SET/OFF
PAD —Used to set
or cancel the minute
timer. The minute
timer does not start
or stop cooking. Also,
TIMER SET/OFF
Pad is used to set
the Continuous Bake"
Feature.
DELAY START
PAD
—Used to set the'
desired start time for
baking. May be used
with COOK TIME to
program a delayed
bake cycle.
COOK TIME PAD
Used to enter the
length of the baking
time.
UP and DOWN ARROWS PADS Used along with the
function pads to select oven temperature, cook time,
start time (when programming an automatic start time)
time of day, clean fime and minufe fimer.
Cbok
Bake
• OVEN
• PREHEAT
• DOOR LOCKED
OVEN, PREHEAT & DOOR LOCK LIGHTS* The “Oven” light will glow
each time the oven unit turns on to maintain the set oven temperature.
The
“Preheat” light will glow when the oven is first set to operate, or if
the desired temperature is reset higher than the actual oven temperature.
The
“Door Locked” light will flash unfil the door locks when the self­
clean cycle is in use. It glows constantly after the door locks.
BAKE
PAD—
Used
to select the
bake function.
FEATURE
INDICATOR
LIGHTS—
These
light to show which
feature is in use.
BROIL PAD—
Used to select
'the variable broil
function.
SELECT CLEAN
PAD —Used to
select the Self-
_Cleaning cycle. A
2 or 3 hours Self­
Clean fime may be
selecfed.
STOP PAD — Used to clear any function
previously entered except the time of day
and minufe fimer. Press STOP to stop
cooking. Also the STOP pad is used to
activate oven lockout setting.
*Note: The OVEN indicator light on the electronic display will turn ON and OFF when using the Bake feature and
during preheat. This is normal and indicates that the oven is cycling to maintain the selected baking temperature.
When the preheat indicator light turns OFF, your oven is ready.
For a silent control panel
When choosing a function, a beep will be heard each time a pad is pressed. If desired, the control can be programmed
I •.
for silent operation. Press and hold sfa'-' . After 7 seconds, the control will beep once. This will block the controls from
I ■
sounding when a pad is pressed. To return the sound, press and hold storC again for 7 seconds until the control beeps
once.
Note: The control will return to the audible mode after a power outage.
Temperature conversion
The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be
programmed for any temperature from 170°F to 550°F (77°C to 287°C).
To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Clean mode):
1. Press . "--------------" appears in the display.
2. Press and hold the until "HI" appears in the display.
3. Press and hold until °F or °C appears in the display.
4. Press the or to change °F to °C or °C to °F.
5. Press any control pad to return to normal operating mode.