FRIGIDAIRE ES200/300 - Manual (Page 17)

Care &
To Remove and Replace Oven Door
To Remove Oven Door:
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges A (one on each
side.)
3. Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up
and off the hinges.
4. To clean oven door, follow the instructions provided in the cleaning chart under General
Cleaning
To Replace Oven Door:
1. Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges
open by hand. The hinges may snap back against the oven frame and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the
door.
3. Hinge arms must go into the range slots evenly. The hinge arms should be inserted into
the bottom corners of the door as far as they can go.
4. If the door is not in line with the oven frame, remove it and repeat the above steps.
ià CAUTION I The door is heavy. For safe, temporary storage, lay the door flat with the inside
of the door facing down.
Care and Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Please refer to the table provided at the beginning of the Care & Cleaning section in this Use
& Care Manual.
Adjusting Your Oven Tern
The temperature in the oven has been set at the factory. When first using the oven, be sure to follow recipe times and
temperatures. If you think the oven is too hot or too cool, the temperature in the oven can be adjusted. Before adjusting, test
a recipe by using a temperature setting that is higher or lower than the recommended temperature. The baking results should
help you to decide how much of an adjustment is needed.
To Adjust Oven Temperature:
1. Press .
2. Set the temperature to 550°F (287®C) by pushing and holding the
3. Within 2 seconds, press and hold until the special 2 digit display appears. Release . The display now indicates
the amount of degrees offset between the original factory temperature setting and the current temperature setting. If the
oven control has the original factory calibration, the display will read "00."
4. The temperature can now be adjusted up or down 35®F (17°C), in 5®F steps by pressing and holding the or
Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus
sign {-} will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.
Clear\ 5. When you have made the desired adjustment, press to go back to the time of day display.
Note: The adjustments made will not change the self-cleaning ternperature,
1 7