Kenmore ELITE 795.7103 - Manual (Page 17)

USING YOUR REFRIGERATOR
SETTING THE CONTROLS
The refrigerator control functions as the thermostat for the
entire appliance (refrigerator and freezer sections). The
colder the setting, the longer the compressor will
run to
keep the temperature colder. The freezer control adjusts
the cold air flow from the freezer to the refrigerator.
Setting the freezer control to a lower temperature keeps
more cold air in the freezer compartment to make it
colder.
AIRFLOW
Cold air circulates from the freezer to the fresh food
section and back again through air vents in the wall
dividing the two sections. Be sure not to block vents while
packing your refrigerator. Doing so will restrict airflow
and may cause the refrigerator temperature to become
too warm or cause interior moisture buildup. (See air flow
diagram below.)
Temperature
Dispenser
• When you press the Water
button, the Water icon will
illuminate.
• When you press the Ice Select
button, either the cube or crushed
ice icon will illuminate.
• Some dripping may occur
after dispensing. Hold your cup
beneath the dispenser for a few
seconds after dispensing to catch
all of the drops.
VJ
A CAUTION: The control display is operated by
touch. Excessive moisture on the display may cause a
malfunction. Please keep the display clean and dry.
A WARNING: The dispenser will not work if any door is
left open or if the control lock is engaged.
Ultra Ice
• When you touch the Ultra Ice button, the graphic will
illuminate in the display and will continue for 24 hours.
The function will automatically shut
off after 24 hours.
• You can stop this function manually by touching the
button one more time.
• This function increases both ice making and freezing
capabilities.
Water Filter Reset
CHANGE FILTER
• The Refrigerator Temp. Control ranges from 33°F to
46°F (0°C to 8°C). Press the Refrigerator Temp, button
to cycle through the available temperature settings one
increment at a time.
• The Freezer Temp. Control range is from -6°F to 8°F
(-21 °C to -13°C). Press the Freezer Temp, button to
cycle through the available temperature settings one
increment at
a time.
NOTE: When changing control settings, wait 24 hours
before making additional adjustments. The controls are set
correctly when milk or juice is as cold as you would like
and when ice cream is firm. If the temperature in either
compartment is too cold or too warm, change the setting
one increment at
a time. Wait 24 hours for the change to
stabilize before adjusting again.
When the water filter indicator turns on, you have
to change the water filter. After changing the water
filter, press and hold the Ultra Ice (Water Filter Reset)
button for three seconds to turn the indicator light off.
You need to change the water filter approximately
every six months.
Blue Ambient Mood Light/Light Sensor =
This light has three settings: On, Off and Auto. If the
light is set to the Auto mode, the Blue
Ambient Mood Light will automatically turn on and
off according to the brightness of room, as detected
by the light sensor.
17