Kenmore GAS A GE-SLIDE IN MODEL 790.3104 - Manual (Page 19)

Consumer Defined Control
Note: The Consumer Defined Control features are adjustments to the control that will not affect cooking results. These
include the Oven Lockout, Temperature Display and Silent Control Operation features
Setting Oven Lockout Feature
The pad controls the Oven Lockout feature. The Oven Lockout feature automatically locks the oven door and
prevents the oven from being turned on. It does not disable the clock, Kitchen Timer or the interior oven lights.
INSTRUCTIONS
To activate the Oven Lockout feature
PRESS DISPLAY
Press and hold
( stop )
for 3 seconds.
2. After 3 seconds "Loc" and Q will appear, a beep will sound
and "DOOR LOCKED" will flash in the display. Once the oven
door is locked the "DOOR LOCKED" indicator will stop flashing
and remain on along with the "Loc" (Figure 1).
To reactivate normal oven operation:
( ^ ^ f o r 3
seconds
Figure 1
1
.
Press and hold for 3 seconds. A beep will sound. The
"DOOR LOCKED" will flash in the display until the oven door
has completely unlocked (Figure 2).
(si^for3
seconds
I
Figure 2
2. The wall oven is again fully operational.
Setting Silent Control Operation
The DELAY TIME and FLEX CLEAN (a^ pads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the
control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
INSTRUCTIONS
To change control from normal sound operation to
silent control operation
1. To tell if your range is set for normal or silent operation press
and hold (^). will appear and "DELAY" will flash in the
display (Figure 3). After 7 seconds "SP" (Speaker) will appear
in the display. (Figure 4)
2. Press to switch between normal sound operation and
silent operation mode. The display will show either "SP"
(Figure 4) o r ( F i g u r e 5).
If "SP" appears (Figure 4), the control will operate with normal
sounds and beeps. I f a p p e a r s (Figure 5), the control is in
the silent operation mode.
PRESS DISPLAY
for 7 seconds
Figure 3
Figure 4
3. Press START to accept the change or press ( stop J to reject the
change.
start ):
or
( stop )
Figure 5
Note: The control will always beep at the end of a kitchen timer and will beep when a set temperature has been reached,
even if the control is set to silent operation.
19