Remember — do not allow spills, food, cleaning, Dual burner head assembly (some models only), Step 2 – Kenmore GAS A GE-SLIDE IN MODEL 790.3104 User Manual
Page 9: Before setting surface controls
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assembly of the Surface Burner Heads, Burner Caps and Burner Grates for Regular Burners
It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates
are installed correctly and at the correct locations.
1. Remove all packing tape from cooktop area. Remove all
Burner Caps and Burner Heads.
Discard all packing material located under Burner Heads (if
applicable).
To replace the Burner Heads & Caps, match the letters
located under center of Burner Caps with the letters located
inside Burner Heads (Figure 1).
Match Burner Skirts with Burner Heads and Burner Caps
(see Figure 1). Replace the Burner Heads and Caps on
cooktop (see Figure 2). Carefully align the Electrodes into
slot or hole of each Burner Head (Figure 3). Note: The
Burner Heads should sit flat on Cooktop Burner Skirts.
Place the removable oven vent cover over the fixed oven
vent cover.
Unpack Burner Grates and position on the cooktop.
Before Setting Surface Controls
2
.
3.
4.
5.
6
.
Figure 3
“ Electrodes must
align into slot or hole for each
Burner Head
REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner
Caps and Burner Heads in place whenever the surface burners are in use.
ir;i
f..
Dual Burner Head Assembly (some models only)
Make sure that the Burner Head, Burner Caps and Burner Skirt are
installed properly and at the correct locations.
1. Follow the Installation Instructions before installing and using your
new range.
2. Remove all packing tape from cooktop and the dual burner.
3. Discard all packing material located under all Burners (if applicable).
4. To install Burner Head, Caps & Skirt, refer to figure 1 and follow the
following steps:
Step 1: Align Burner Head Pin A on Burner Base Hole.
Step 2: Place Burner Skirt around Head and Base.
Step 3: Align the Burner Outer Cap Hole into Burner Head Pin B.
Step 4: Place Inner Burner Cap centered on Burner Base.
5. Put back the grates on the cooktop.
REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
ORIFICE HOLDER OPENING. Always keep the Burner Caps and
Burner Heads in place whenever the surface burners are in use.
Burner
Inner Cap
Burner —
Outer Cap
Burner Outer
Cap Hole
Burner
Skirt
Step 4
Step 3
Step 2