Electronic control operating instructions, Air conditioner features, Using air conditioner – Kenmore 309000845 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using Air Conditioner
A WARNING
To reduce the risk of fire, electric shock, or injury to persons, read
the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
NOTE: If the air conditioner is turned off
or the temperature is changed to a lower
setting then back to a higher setting the
compressor will shut off. Wait 3 minutes
before the compressor will restart, this
allows for the pressure inside the
compressor to equalize.. Failure to wait 3
minutes may cause inefficient operation.
When adjusting the temperature the fan
will continue to run.
To begin operating the air conditioner, follow these steps:
1. Plug in the air conditioner. (To prevent electrical hazards, do not use an extension
cord or an adapter plug.)
2. Set the exhaust vent to the CLOSED position.
3. Press "On/Off" button to turn unit on.
4. Press Fan Speed "HI"
5. Press Mode "COOL"
6. Press "TEMP/TIME" down to the lowest setting "60 degrees"
7. Adjust the louvers for comfortable air flow.
8. Once the room has cooled, adjust the “TEMP/TIME" and Fan Speed to desired
temperature.
Review the "Air Conditioner Features" section for other settings.
Air Conditioner Features
ON/OFF.
LOWERS
TEMPERATURE
OR TIME
RAISES
TEMPERATURE
OR TIMES
SETS
MODE
ELECTRONIC CONTROL OPERATING INSTRUCTIONS
Before you begin, thoroughly familiarize yourself with the control panel and remote
as shown below and all its functions, then follow the symbol for the functions you
desire. The unit can be controlled by the touch pad alone or with the remote.
DISPLAYS
TEMPERATURE/TIME
TURNS UNIT
ON OR OFF
SETS FAN SPEEDS
SETS MODE
Slip battery cover off and pull the piece of plastic from between
the battery end and the conneaor.
PLASTIC
PIECE