Operating instructions, Lighting, Awarning – Kenmore 153.33459 User Manual

Page 17: Check for leaks, Lighting -18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Operating Instructions

Lighting

AWARNING

BEFORE

LIGHTING

[PROPANE

(L.P.)

GAS

WATER

HEATERS]; Propane (LR) gas is heavier than air. Should there

be a leak in the system, the gas will settle near the ground.

Basements, crawl spaces, skirted areas under mobile homes
(even when ventilât^, closets and areas below ground level will
serve as pockets for the accumulation of this gas. Before

attempting t» light or relight the water heater^ pilot or turning
on a nearby elecbical light switch, be absolutely sure there is no

accumulated gas in the area. Search for odor of gas by sniffing at
ground level in the vicinity of the appliance, if odor b detected,
follow steps indicated at "For Your Safety" on the cover page of
this manual then leave the premises.

-

Lighting and operating instructions are located on front of the

water heater, above or to one side of the gas control valve.

AWARNING

AN ODORANT IS ADDED TO THE GAS USED

BY THIS WATER HEATER.

FOR YOUR SAFETY
IF YOU SMELL GAS:
* Do not try to light any appliance.
> Do not touch any electrical switch; do not use any phone in

your building.

* Immediately call your gas supplier from a neighbor^ phone.

Follow the gas suppliei^ instructions.

* If you cannot rea^ your gas supplier, call the fire depart­

ment

AWARNING

DO NOT force the gas control knob. Use only your hand to
push it down to light the pilot, or to turn it to “ON", “OFF”
or “PILOT”. Never use a tool such as a lever, wrench or pli­
ers. Do not hit or damage the knob. A damaged knob may
result in an explosion and serious injury. If you have problem
turning the knob, call the gas supplier imm^iately.

CHECK FOR LEAKS

Be sure to check all your gas pipes for leaks before lighting your

water heater. Use a soapy water solution, not a match or open

flame. Check the factory gas fittings after pilot is lit and gas con­

trol knob is still in “PILOT” position. Then, check the fittings

when the main burner is turned “ON”. Use a soapy water solu­

tion for this, too.

Figure 6

Figure 7

Figure 8

Figure 9

MANIFOLD

COVER

17

Advertising