Kenmore 153.33459 - Manual (Page 24)

Operational Conditions
(cont’d)
HIGH TEMPERATURE SHUT OFF SYSTEM
Troubleshooting Guide (cont*d)
This water heater is equipped with an automatic gas shut off sys­
tem. The high temperature shut off is built into the gas control
valve. This system shuts off the gas supply to the water heater
burners when high water temperatures are present. It is non­
resettable. If the high temperature shut off activates, the gas con­
trol valve must be teplaced. If this were to occur, turn “OFF” the
entire gas supply to the water heater. Contact the Sears Service
Center.
A WARNING
Should overheating occur or the gas supply fail to shut off,
turn “OFF” the manual gas control valve to the appliance.
NOT ENOUGH OR NO HOT WATER
• Check the manual gas shut off valve to be sure it is open.
• Check the pilot flame. It may have gone out. All models have
an opening behind the outer door for viewing the pilot,
• If the pilot is not lit, follow the “Lighting” instructions in this
manual or located above the gas control valve on the water
heater to relight the pilot. If the water was extremely hot and is
now cold, the high limit safety temperature shut off may have
put out the burner and pilot. If the high temperature shut off
activates, the gas control valve must be replaced. Contaa the
Sears Service Center.
• The gas control knob must be turned to the “ON” position.
• The temperature adjustment dial may be set too low. See the
“Temperature Regulation" section.
• The gas company can check the gas input to see if it is correct.
An undctfired water heater will not heat water as quickly.
• Look for leaking or open hot water (aucets. Make sure all are
, closed,
• The cold water inlet temperature may be colder during the winter
months. It will take longer to heat the water and seem like
less hot water.
• If you cannot find what is wrong, call the Sears Service Center.
WATER IS TOO HOT
• The temperature adjustment dial may be set too high. See the
“Temperature Adjustment” section.
NQI^ A period of time is necesaaiy after an adjustment
has been made for the water temperature to reach the new
temperature setting.
• If lower temperature settings will not lower the water tempera­
ture, call the Sears Service Center.
AWARNING
HOTTER WATER CAN SCALD: Water heaters are intended to
produce hot water. Water heated to a temperature vdiich will
satisfy clothes washing, dish washing, and otfier sanitizing needs
can scald and permanently injure you upon contact Sonrte peo­
ple are more lilmly to be permanently injured by hot water than
others. These include the elderly, children, the infirm, or physicah
ly/mentally handicapped. If anyone using hot water in your home
Às into one of these groups or if there is a local code or state law
requiring a certain temperature water at the hot water tap^ then
you must take special precautions. In addition to using the lowest
possible temperature setting that satisfies your hot water needs,
a means such as a mixing valve, should be used at the hot water
taps us^ by these praple or at the water heater. Mixing valves
are available at plumbing supply or hardware stores. Follow man­
ufacturers instructions for installation of the valves. Before
changing the factory setting on the thermostat, read the
'Temperature Regulation” section in this manual.
AWARNING
Due to the nature of the typical gas water heater, the
water temperature in certain situations may be hotter
than the thermostat setting.
Short, frequent draws of hot water - especially with very
cold incoming water - can shock the thermostat into brief
operation resulting in hotter and hotter layers of water
closer to the top of the tank.
Changes in hot water usage patterns or raising the tem­
perature differential between the cut-on of the thermo­
stat and the cold water temperature will usually eliminate
the problem.
24