Kenmore 790.4672 - Manual (Page 17)

Setting the Clock
pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
Setting Oven Controls
The
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash (See Figure 1).
1 .
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press (^). "CLO" will appear in the display (Figure 2).
2. Press pads to set the time of day to 1:30
(Figure 3). "CLO" will stay in the display. Press start " c LO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
Press and hold (^) for 7 seconds. "CLO" will appear in the
display. After 3 seconds Q will appear in the display indicating
that the cooktop lockout is active (Figure 5). CONTINUE
holding the pad until "12h" (Figure 6) or "24h" (Figure 7)
appears in the display and the control beeps once.
to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 6) or "24h"
(Figure 7).
Press START : to accept the change or press to reject the
change. Q will disappear from the display.
Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
3.
4.
PRESS
®<D(D
START
for 7 seconds
START ; or STOP
t j-nn
i C - U U
Figure 1
DISPLAY
I
Figure 2
: 3 D C L 0
Figure 3
Figure 7
17