Honeywell Y594G User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4.
Level the subbase using a spirit level, as shown in
Fig. 3, and firmly tighten subbase mounting screws. The
subbase mounting holes provide for minor out-of-levef
adjustments.
■ IMPORTANT-
A subbase incorrectly leveled will cause the temper
ature control to deviate from set point.
WIRING THE SUBBASE
All wiring must comply with local electrical codes and
ordinances. Follow equipment manufacturer's wiring
instructions when available. To wire subbase, proceed as
follows:
1.
Connect system wires to the subbase as shown in
Fig. 4 or 5. A letter code is near each terminal for identifica
tion. The terminal barrier permits straight or conventional
wraparound wiring connection (Fig. 6).
69-0272—1