CatEye EC-L32OO - Manual (Page 11)

18
No display appears
or abnormal display
a p p e a r s o n t h e
LCD panel.
Buzzer beeps con-
tinuously.
"Distance Scale
Unit" display is
wrong.
T h e p u l s e r a t e
reading is not dis-
played.
The target pulse
rate alarm does not
beep.
Press the advance button and
check if the display appears or not.
Proceed "All-clear Process", and
press the advance button and
check if the display appears or not.
[Page 10 (Fig. 4)]
Check if your upper-limit pulse rate
(PLL) has been set correctly. [Page
13-2]
Check if the distance scale unit was
set correctly according to instruc-
tions. [Page 5-7]
Check if the sensor plug is inserted
properly. [Page 7-5]
Check if the pulse sensor is cor-
rectly attached to your earlobe.
[Page 7-6]
Check if the plug or the cable of the
pulse sensor is damaged. [Page 7]
Has your pulse rate once reached
the target pulse rate? [Page 10]
Is the Target Pulse On/Off mark
lit on the screen? [Page 10]
If still no display ap-
pears, the batteries are
dead. Replace all four
batteries. [Page 10 ]
Input your age correctly.
The upper-limit pulse
rate is set at [200 – age].
Follow instructions on
page 6-1 to set the de-
sired distance unit.
Insert the sensor plug
properly, and attach the
pulse sensor correctly.
In case of damage on
the pulse sensor, re-
place it with a new one.
The target pulse rate
alarm is activated only
after your pulse rate
reaches the target.
Press the Target Pulse
O n / O f f b u t t o n t o
turn on the mark.
Trouble Shooting / Warranty Service
Specifications
Trouble Shooting
Trouble Check Item Suggested Remedy
Warranty Service
• Cat Eye Co., Ltd. guarantees that the Cateye Ergociser™ Model EC-L3200 is free
from material defects and malfunctions under correct and normal use for a period
specified in the separate Warranty Card. In case there should be defects or malfunc-
tions, Cat Eye will repair or replace the unit or parts, according to the terms and
conditions mentioned in the Warranty Card.
• If repair service is required, contact your dealer where the unit was purchased.
• The warranty covers only the main unit and the control unit. Accessories such as the
pulse sensor are not covered.
ITEM SPECIFICATIONS
Load Eddy current system utilizing permanent magnet
Load Range Manual Adjustment 1 ~ 8 level
Cadence 50 ~ 120 rpm
Load Range 25 ~ 680 watts
Acceleration 2-step belt drive
Control System 4-bit micro-computer
Display Function Function Range Accuracy
Pulse Rate 50 ~ 220 bpm ± 1 bpm (stable state)
Cadence 20 ~ 240 rpm ± 1 rpm
Exercise Time 00 min. 00 sec. ~ 99 min. 59 sec. ± 0.003 %
Work Rate 0 ~ 999 watts ± 5 watts (at 50 watts)
Speed 0 ~ 99 miles/h (km/h) Simulated value
Distance 0.00 ~ 99.99 miles (km) Simulated value
Calorie 0 ~ 999 kcal Estimated value
Alarm Function Target Pulse Rate Alarm
Signals if the pulse rate deviates from target pulse rate zone
Upper-limit Pulse Rate Alarm
Signals when pulse rate exceeds preset upper-limit pulse rate
Exercise Time Alarm
Signals when preset target exercise time is reached
Power Supply AA (R6) x 4 (Battery life: Approx. 200 hours by alkaline battery)
User's Weight Limit 286 lbs (130 kg)
Measurement Handlebar Height: 39-7/32 ~ 52-7/16 inches (996 ~ 1332 mm)
Saddle Height: 33-9/32 ~ 46-31/32 inches (845 ~ 1193 mm)
Length: 42-11/32 inches (1075 mm)
Width: 19-11/16 inches (500 mm)
Weight Net Weight: 55.5 lbs. approx. (27 kgs)
* Specifications and design are subject to change without notice.
U.S. Pat. 4929825 / Design Pat. Pending
Copyright© 2000
Cat eye Co., Ltd.
Printed in Japan
ECMeL32-000118- 1
19