Sharp AF-S125NX - Manual (Page 13)

HOW TO OPERATE
TO OPERATE ON FAN: YOU WILL SEE:
LIGHT ON
Note: Use this function only when cooling is not desired, such
as for room air circulation or to exhaust stale air. (Remember
to open the vent during this function, but keep it closed during
cooling for maximum cooling efficiency.) You can choose any
fan speed you prefer.
During this function, the display will show the actual room tem­
perature, not the set temperature as in the cooling mode.
TO USE THE ENERGY
SAVE: YOU WILL SEE:
6MS>
(SMS’
LIGHT ON
Note: In this mode, the fan will continue to run for 3 minutes
after the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the room temperature is
above the set temperature, at which time the compressor turns
back on and cooling starts.
TIMER:TIMER ON/OFF YOU WILL SEE HOW MUCH TIME IS CHOSEN:
LIGHT ON
Note: For Timer Off, the unit must be in the On position.
Note: For Timer On, the unit must be in the Off position.
To adjust timer setting, tap or hold the UP arrow( A) or the
DOWN arrow(^) to change delay timer at 0.5 hour incre­
ments, up to 10 hours, then at 1 hour increments up to 24
hours. The control will count down the time remaining until
start (8, 7.5, 7, etc.). The Timer On mode automatically
selects cooling with maximum Fan Speed. The temperature
maintained will be the same as previously set. To change the
set temperature, press “MODE” then Up or Down arrows until
the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display
back to the hours remaining until the unit will start/stop.
Turning the unit “ON” or “OFF” at any time will cancel the Timer
On/Off function.
The Timer On/Off Feature will work until the unit either
starts or stops. Once that happens the above steps have to be
repeated again. . _
13