Cavalry Storage CADA-U3E4 - Manual (Page 4)

CADA4-U3E
2
5.
6.
7.
8.
9.
10.
USB
eSATA
ERROR REBUILD
POWER
HDD 4
HDD 3
HDD 2
HDD 1
EASY YOUR PC
4-BAY RAID HDD Backup Solution
1.
2.
3.
4.
1. Interface LED
2. Power Button
3. HDD Trays (4)
4. HDD Status LEDs
5. Reset/Set Up Button
6. Mode Setting Switch
7. eSATA Connector
8. USB 3.0 Connector
9. HDD Power Switch
10. Power DC In
USB 3.0 Cable
Power Supply
PRODUCT PART IDENTIFICATION
1
CHAPTER GETTING STARTED
TOOL-LESS DRIVE-BAY INSTALLATION
The tool-less drive-bays are designed to be secure and have as few
parts as possible. However, accomplishing this requires that the user
have a strong grasp! To remove the drive bays, pinch the front handle
firmly until you are able to compress the blue plastic levers inside.
Next pull back slowly until you feel the blue plastic levers clear the
edge of the case. Now slide the drive bay all the way out of the
endclosure.
The image to the left shows you the potential drive placement.
To remove and replace the internal HDD, gently pry the blue retainer
pins from both sides of the HDD. Set the tray down and continue with
your swap.
The CADA-U3E4 is designed to be hot-swappable. But if you have
already setup an active 4-disk array, be careful not to insert any new
drives. The automatic rebuild function will incorporate any new drives
into the existing array. That means any existing data on the new drive
will be wiped clean to accommodate the active array!