Kenwood KT-5020 - Manual (Page 3)

Before applying power
A Caution: Read this page carefully to keep your safety.
For the U.S.A. and Canada For Australia and Europe
Important!
Units shipped to the U.S.A. and Canada are designed for
operation on 120 volts AC only.
Safety precaution for a Ploarized AC plug
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES
CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
For the United Kingdom
Important!
Units shipped to the U.K. are designed for operation on 240
volts AC only.
The mains plug must be removed from the wall socket prior to
any internal examinaiFon.
The wires in this mains lead are coloured in accordance with
the following code:
Blue ...................... .............................. Neutral
Brown..............................................— Live
The wires in this mains lead must be connected to the
terminals in the plug as follows:
Wire colour
Plug terminal marking
Biue...... .................—---- ----------------- N or Black
Brown............................................... L or Red
fuse.
2. if a 3-pin plug with earthing contact is used, no wire must
be connected to the E terminal.
Safety precautions
Important!
Units shipped to Australia are designed for operation on
240 V AC only.
Units shipped to Europe are designed for operation on 220 V
AC only,
For other countries
ImportantI
Units shipped to countries other than the above countries are
equipped with an AC voltage selector switch on the rear
panel. Refer to the following paragraph for the proper setting
of this switch.
AC voltage selection
This unit operates on 1 1 0-1 20 or 220-240 volts AC. The AC
voltage selector switch on the rear panel is set to the voltage
that prevails in the area to which the unit is shipped. Before
connecting the power cord to your AC outlet make sure that
the setting position of this switch matches your line voltage,
If not, it must be set to your voltage in accordance with the
following direction.
Note: -----------------------------------------------------------------------------------
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector
switch.
AC 110- AC220-
120V - 240V-
AC110- ACS220-
120V- 240V-
1-1
Fig. 1
1. Before plugging in this unit, make sure that the position of
the AC voltage selector conforms to your line (mains)
voltage, If not, it must be reset. See Fig. 1-1.
2. To reset the selector, slide the stopper plate to the
opposite side with a screwdriver or other pointed tool. See
Fig. 1-2.
3. Insert the power cord securely. See Fig. 1-3.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
TO RAIN OR MOISTURE.
DO NOT EXPOSE THIS APPLIANCE
A 1 CAUTION 1 A A
CAUTION; TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SER­
VICING TO QUALIFIED SERVICE PERSONNEL
A
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIAN­
GLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DAN­
GEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT
MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
A
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT
THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SER­
VICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
A Caution: Read this page carefully to ensure safe oper-