Chapter 5 using your hdtv for the first time, Select input source, Watching a tv program – Vizio E322VL User Manual
Page 18: Select input source watching a tv program
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
VIZIO E322VL User Manual
Chapter 5 Using your HDTV for the first time
Select Input Source
Select the input source for your HDTV by pressing INPUT on the
remote control or the side of your TV. Pressing this button will
cycle you through the following options: TV, AV (Composite),
Comp, HDMI-1, HDMI-2, HDMI-SIDE and RGB (VGA).
Turn on your device and you will see a picture on your HDTV. If
there is no picture, make sure you have selected the correct input
on your HDTV.
If the selected device is RF connected, your HDTV must be
in TV mode and on either channel 3 or channel 4 matching the channel which has been selected on the
back of the VCR, Cable Box, External TV Tuner or Satellite Receiver. Refer to Cwner or User’s Manual of
such equipment for details.
Watching a TV Program
Before you start watching TV, make sure that any Cable, Satellite or off-air antenna connections are
secure. Also, verify that the power cord is plugged into a correctly grounded electrical outlet or surge
protector.
1. Press the power button on the remote control. The VIZIC logo on the front will light up white.
2. Select the input to which your device is connected that provides TV programming (e.g. TV, HDMI
AV).
You should be able to see a picture. If you do not, make sure that all of your HDTV connections
are secure and you have selected the correct video input source. Each press of INPUT on the remote
control will cycle through the available inputs. Press the button until the input associated with the device
you want to view is shown.
3. When using the TV input, press the channel buttons on the remote control or on the TV. The
channel buttons will not work if you are watching a program using HDMI or AV inputs.
If your HDTV is in TV mode, pressing CH+ and CH-will network until a channel scan has been
been run. See Auto Channel Search on page 36.
18