Flush mount application, Attaching adapter plate to projector, Caution – Epson ELPMBPJF User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Flush Mount Application
Screw projector mount (A) into ceiling plate (G). Align the notch with one ofthe four holes ofthe ceiling
plate (G) and secure projector mount (A) with aM5x10 mm socket pin screw (C) using security allen
wrench (B) as shown in detail 1.
NOTE: Slotted set screw (K) is used tojam against the threads of mount to prevent any excess movement of
the projector mount (A). Do not overtighten screw; overtightening screwwill damage threads making it difficult to
o
Attaching Adapter Plate to Projector
©
NOTE: The projector you are installing may differ
in appearance from the sample illustrated below.
NOTE: Some projectors may have three orfour
attachment points. If projector has three attach
ment points, the unused leg may be removed.
Place projector upside down. Locate adapter
plate (L) with notch* facing forward as close to
projector center of gravity as possible without
covering any mounting holes. Loosen channels,
and ifthere are only three mounting holes re
move fourth channel. Using one channel for each
mounting hole, position feet of channels over
mounting holes as shown. Important: If projector
does not have at least three mounting holes, do
not use this adapter plate. Once channels are in
position retighten fasteners.
NOTE: Some projectors have feet which can be
removed and the corresponding threaded insert
can be used for a mounting hole.
*Notch indicates front of projector.
CAUTION
It is the responsibility of the installer to ensure that
the projector is properly ventilated. Feet of channels
are used to raise the mount off the projector surface.
7 o f 1 0
ISSUED:01-23-07 SHEET #:055-9498-4 05-20-10
For Technical Support Contact Peerless Mounts at 1-800-729-0307 or708-865-8870.