Lubrication, Fuel filter, Cleaning the engine – Toro 13AX60RG744 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8. Check the gap using a feeler gauge and adjust, if
necessary, by carefully bending the ground
electrode. See Figure 20. Set the spark plug gap to
0.030 in (0.76 mm).
Lubrication
9. Reinstall the spark plug into the cylinder head.
Torque the spark plug to
28/32 ft. lb. (38.0/43.4
N-m).
10. Place the spark plug wire boot over the spark plug
and press until you feel it “click” in place.
Fuel Filter
A
WARNING:
Do not replace the fuel filter
when the engine is hot.
The engine is equipped with an inline fuel filter located
on the right side of the engine.
Visually inspect the filter periodically for a build-up of
residue inside the filter body, and for a dirty element
which can be indicated by discoloration. Replace the
fuel filter when dirty.
Cleaning the Engine
Any fuel or oil spilled on the machine should be wiped
off promptly.
Do NOT allow debris to accumulate around the cooling
fins of the engine or on any other part of the machine,
especially the belts and pulleys.
A
WARNING:
Before lubricating, repairing, or
inspecting, always disengage PTO, set
parking brake, stop engine and remove key to
prevent unintended starting.
Engine
Refer to
Engine
on page 22 for instruction regarding all
engine-related lubrication.
Front Wheels
Each of the front wheel axles and rims is equipped with
a grease fitting. See . Lubricate with 251H EP grease or
an equivalent No. 2 multi-purpose lithium grease after
every 25 hours of tractor operation.
Pivot Points & Linkage
Lubricate all the pivot points on the drive system,
parking brake and lift linkage at least once a season
with light oil.
25