Changing the transmission drive beit, Changing the deck beit – Toro 13AX60RG744 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. Pull the deck support pin outward to release the
deck from the deck lift arm. See Figure 25.
•
Repeat the above steps on the tractor’s right side.
•
Move the deck lift lever into the top notch to raise
the deck lift arms up and out of the way.
•
Gently slide the cutting deck toward the front of the
tractor allowing the hooks on the deck to release
themselves from the deck stabilizer rod.
•
Gently slide the cutting deck (from the right side)
out from underneath the tractor.
Changing The Transmission Drive Beit
NOTE:
Several components must be removed and
special tools (i.e. air/impact wrench) used in order to
change the tractor’s transmission drive belt. See an
authorized Toro service dealer to have your drive belt
replaced.
Changing the Deck Beit
A
A
WARNING:
Be sure to shut the engine off,
engage the parking brake and remove the
ignition key to prevent unintended starting
before removing the belt.
WARNING:
Avoid the possibility of a
pinching injury. Do not place your fingers on
the idler spring or between the belt and a
pulley while removing the belt.
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
IMPORTANT:The V-belts found on your tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the deck belt on your tractor,
proceed as follows:
•
Remove the cutting deck as instructed earlier in this
section.
•
Remove the belt covers by removing the screws
that fasten them to the deck. Refer to the figure on
the following page.
•
Loosen, but do not remove the deck idler pulleys.
•
Remove the deck belt from around all pulleys,
including the deck idler pulleys.
•
Route the new belt as shown in the figure below
and retighten the deck idler pulleys.
•
Reinstall the belt guards removed earlier and
remount the deck to the tractor.
Changing the Lower Deck Belt (Model LX460 only)
NOTE:
Several components must be removed in
order to change the lower deck belt (Model LX460). See
an authorized Toro service dealer to have this drive belt
replaced.
28