Connecting the am antenna, Rear panel of the center unit (ca-fsx1/ca-fsx3) – JVC FS-X 3 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Connecting the AM Antenna
Rear Panel of the Center Unit (CA-FSX1/CA-FSX3)
AM loop antenna (SuppNed)
Outdoor single vinyl-covered wire (not supplied)
Attach the AM loop to its base by snapping the tabs on
the loop into the slot in the base.
Notas
* •
• //
the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord.
This could cause poor reception.
• if reception is poor, connect an outdoor single vinyi-covered wire to the AM EXT terminal. (Keep the AM loop
antenna connected.)