CLEAR Hub Express Users Guide - Manual (Page 6)

5
Set up the Device (continued)
Connect to CLEAR 4G Network
As the device is searching for the CLEAR 4G network, five LED lights, located on the front of the device, will
blink sequentially and then in unison. When the device is connected to the CLEAR 4G network, the LED lights
will stop blinking and remain lit.
Note: The number of LED lights indicates the CLEAR 4G signal strength – the more lights, the stronger the
signal. For optimal signal strength, you should try different locations for the device to ensure a minimum of
two LED lights are lit. If at least two LED lights are not lit, try moving the device to another room.
Move just the device (not your computer) to another room, and wait 15—20 seconds after the LED lights are
solid white, in order to obtain the most accurate reading of the CLEAR 4G network.
To optimize the signal strength in the device’s current location, try turning the Device by small 1/4”
increments.
Signal Strength
Indicator