COMEUP Industrial Winch (Ver:03) - Manual (Page 13)

12
Cable-in / Cable-out Operation
1).To determine “Cable - Out”, trigger → out
2).To determine “Cable - In”, trigger ← in
3).To stop winching, release the trigger
VIII. Electric Operation
( For Rhino Winch and Wolf Winch )
Control with Thermal Sensor – Warning LEDs (for Rhino Winch Only)
The warning LEDs are shown on the remote control. You shall stop operation and allow winch
to cool (Green LED) when the Red LED was illuminated.
Battery Recommendations
A fully charged battery and good connections are essential for the proper operation of your
winch. The minimum requirement for battery is 650 cold cranking amp.
Remark: 1. The purpose of drum drag brake is to prevent the drum from overrunning the wire rope
when “free-spooling” and it will not be replied on to control or hold a load.
2. The drum drag brake is only available for HV-8/10.
Functions LEDs
Plug in the Winch Green
Normal Winching
Conditions
Green
Abnormal winching
Conditions
Red
Stop the Winch Green (Normal winching) (Abnormal winching)
●
For Yak Winch
●
For HV Winch