COMEUP Industrial Winch (Ver:03) - Manual (Page 15)

14
Brake Adjustment
●
For Rhino Winch with Cone Brake System
Under normal use, the brake mechanism will not require any adjustment. If the brake fails
to hold a load, the brake disc may be worn and require replacement.
When the brake wears to the point that the load begins to slip, the brake can be adjusted
as follows:
1). Loosen the bolts and remove the brake cover, take of retaining rings.
2). Insert a few washers to maintain the brake spacer between to be 2.2 ± 0.25 mm.
3). Make sure to keep the clutch base plate counter-clockwise by 150 – 180 degree.
●
For Wolf Winch, it was designed by ratchet brake, so no need for further brake adjustment.
Lubrication
All moving parts in the winch are permanently lubricated at the time of assembly. Under
normal conditions factory lubrication will suffice. If re-lubrication of gear box is necessary after
repair or disassembly use Shell EP2 or equivalent grease with enough quantity. Clutch T-handle
lubricates regularly with light oil. It is not allowed to have brake assembly lubricated.