COMP Cams 6506 Hi-Tech Belt Drive Supplement User Manual
COMP Cams For the car
Advertising
Hi-Tech Belt Drive Supplement
(#6502 & #6506)
Special Instructions
If the snout diameter on the harmonic balancer to be used with the belt drive system measures larger
than 2.175,” it will need to be modified. The balancer must be machined to 2.155,” .750” from the
end. This will allow the balancer to properly mate to the crankshaft pulley.
The picture on the left is an unmodified balancer. The picture on the right is what a machined balancer
should look like.
Part #181
Revised 12/12/03
Competition Cams, Inc
3406 Democrat Rd.
Memphis, TN 38118
(901)795-2400 FAX (901)366-1807
www.compcams.com
Unmodified Balancer
Machined Balancer
Advertising
This manual is related to the following products: