Comtrol VS1100 Configuration Guide - Manual (Page 19)

Connecting Devices 19
Installing the Hardware
Connecting Devices
Use the following procedure to connect RS-232 asynchronous devices
to the VS1000/1100 ports. The following figure illustrates a modem
bank environment.
1. Connect your RS-232 devices to Ports 1 through 16, for each
VS1000/1100. RJ45 to DB25 cables are available from Comtrol.
Note: Use the modem manufacturer’s hardware installation
documentation if you need help with modem pinouts. If you
need information about VS1000/VS1100 connectors, see the
section titled Building Cables.
2. Install or reconfigure VS-Link using the instructions for your
operating system.
VS1000
COM5-
COM20
VS1100
COM21-
COM36
VS1100
COM37-
COM52
VS1100
COM53-
COM68
Modem Banks
Modem Banks
Modem Banks
Modem Banks