Comtrol WCom2 - Manual (Page 17)

Port Monitor and Test Terminal User Guide: 2000485 Rev. B PortVision DX - 17
Installing PortVision DX
9. Click Launch PortVision DX and Finish in the last installation screen.
10. Depending on the operating system, you may need to click Yes to the Do you
want to allow the following program to make changes to this computer? query.
11. Select the Comtrol Ethernet-attached products that you want to locate and
then click Scan.
Note: If the Comtrol Ethernet-attached product is not on the local segment
and it has been programmed with an IP address, it will be necessary to
manually add the Comtrol Ethernet-attached product to PortVision DX.
If you need additional information about PortVision DX, refer to the Help
system.
12. Go to Using Port Monitor (PMon2) on Page 19 or Using Test Terminal on Page
23 for procedures on using these applications.
You can save time if you only scan for DeviceMasters.