Hold the back of the shelf with one hand, Flip-up shelf, On some models) – Crosley 2211602 User Manual

Page 14: Adjustable flip-up shelf, Lower the shelf securely back into position, Deli drawer

Advertising
background image

14

To remove the shelf:

NOTE: The shelf is heavy and must be removed using
both hands.

1. Hold the back of the shelf with one hand.

2. Lift the front of the shelf with the other hand to a 45° angle

and lower it slightly to release it from the upper channel of the
track. Pull the shelf straight out.

To remove and replace the shelf track:

1. Remove the shelf track by lifting both sides of the track

slightly and pulling the track straight out.

2. Replace the track by guiding the track hooks into the shelf

support slots on the back wall.

NOTE: Make sure that both sets of track hooks are in the
slots and that the slots are parallel with each other.

3. Push the track back and down securely into the shelf

supports.

To replace the shelf:

NOTE: Make sure that both of the rear shelf slides are securely in
the track before letting go of the shelf. The lateral shelf may be
difficult to install if the track is placed too close to the refrigerator
ceiling. Reposition the track on a lower rung until the shelf can be
tilted enough to easily slide into the track.

1. Hold the shelf at the front and tip the front at a 45° angle to

the track.

2. Insert both of the rear shelf slides into the upper channel of

the track, and lower the front of the shelf into place.

Flip-up Shelf

(on some models)

1. To raise the shelf, pull forward on the lever located at the

bottom front of the shelf and lift until the shelf locks into the
vertical position.

2. To lower the shelf, lower the shelf until it is latched securely

in place.

Adjustable Flip-up Shelf

(on some models)

To raise and lower the shelf:

1. Raise the shelf by first sliding it back and down to make it

half-width. (You can use the shelf in this position to allow
taller items to be stored on the shelf below.)

2. Lift the front of the shelf until it fits securely in place against

the back wall.

3. Lower the shelf securely back into position.

4. Pull the front of the shelf forward until it fits into place.

Deli Drawer

(on some models)

The deli drawer stores raisins, nuts, spreads, and other small
items at normal refrigerator temperatures.

To remove and replace the deli drawer:

1. Remove the deli drawer by sliding it straight out to the stop.

Lift the front and slide the drawer out the rest of the way.

2. Replace the deli drawer by sliding it back past the stop.

Convertible Vegetable/Meat Drawer,

Crisper and Covers

(on some models)

To remove and replace the crisper and convertible vegetable
meat drawers:

1. Slide crisper or meat drawer straight out to the stop. Lift the

front of drawer with one hand while supporting the bottom of
drawer with other hand and slide the drawer out the rest of
the way.

2. Replace the crisper or meat drawer by sliding it back in fully

past the drawer stop.

LOW

LOW

HIGH

HIGH

Advertising